Measurement practice
Solutions and knowledge for measurement practice
Practical knowledge on fiber, PON, Ethernet, WLAN and DSL: select measurement tasks, follow procedures and find the matching ARGUS test equipment.
Select a measurement task
Select your application and see which measurement methods, functions and ARGUS testers are suitable.
Expertise and measurement methods
Selected specialist articles on acceptance testing, troubleshooting and complete connection testing.
This selection applies to the articles below:
How do I perform a PON-FMT acceptance test in accordance with ZTV43?
When performing acceptance testing on a GPON or XGS-PON connection, it is not enough to simply measure an optical level. What matters is whether the measured value matches the actual network topology and whether the technician is actually located on the intended PON branch. The PON-FMT acceptance test …
Including flyer for the PON-FMT option according to ZTV 43
How do I thoroughly test an FTTH connection—from the fiber-optic cable to the Internet?
An FTTH connection can be technically flawless and still not work properly for the customer. For example, a good PON level does not necessarily mean that the ONT will register correctly, that an IP connection will be established, or that the subscribed data rate will actually be achieved. A thorough test…
5 minutes reading time
How do I find out where a fault is located on an active PON?
An optically low signal level at a GPON or XGS-PON port initially indicates only that there is a problem—not where it is located. To perform targeted troubleshooting, the technician must therefore determine at which point along the fiber-optic link the abnormal attenuation…
3 minutes reading time
How can I test a GPON or XGS-PON connection if the ONT isn't registering?
If an ONT does not register with the OLT, this does not automatically mean that the ONT is defective. The cause can lie at various levels: with the fiber optic cable and the optical signal level, with the assignment to the correct PON, with ONT authentication, or…
3 minutes reading time
How can I measure GPON and XGS-PON simultaneously on a single fiber?
GPON and XGS-PON can be transmitted in parallel over the same fiber optic cable, since both technologies use different wavelengths. For technicians, this means that multiple optical signals may be present simultaneously at a single port. To evaluate these correctly, the individual…
3 minutes reading time
When do I need a power meter for FTTH, and when do I need an OTDR?
During the installation, acceptance testing, or troubleshooting of an FTTH connection, power meters and OTDR s are used for different tasks. An optical power meter (OPM) measures how much optical power arrives at a specific measurement point. An OTDR (Optical Time Domain Reflectometer), on the other hand, analyzes the…
4 minutes reading time
Technical articles
Current specialist articles on acceptance, fiber optics and measurement methods from the field.

The most costly mistake occurs during commissioning
Why a lack of acceptance tests leads to time-consuming service call-outs With 25 million ‘homes passed’, the roll-out of fiber-optic networks in…

Optical Loss Test Set in Fiber-Optic Network Deployment
It’s the result that counts: the Optical Loss Test Set determines the optical attenuation of a fiber link based on the transmit and receive power levels.
Technical questions
Answers from ARGUS support on operation, firmware, fiber, copper, Ethernet and accessories.
